@article{oai:ir.kagoshima-u.ac.jp:00014026,
 author = {田淵, 大介 and TABUCHI, Daisuke and 佐島, 隆生 and SAJIMA, Takao and 貝沼, 重信 and KAINUMA, Shigenobu and 八木, 伸曉 and YAGI, Nobuaki and 内田, 大介 and UCHIDA, Daisuke},
 journal = {鹿児島大学工学部研究報告, The Research Reports of the Faculty of Engineering, Kagoshima University},
 month = {Dec},
 note = {In this study, to obtain the fundamental knowledge of machining of grooves in inclined surface by a carbide burr, the cutting tests were carried out on model specimens. The cutting force was measured depending on cutting conditions of the carbide burr. From the experimental results, the condition that cutting depth is small and the feed rate of the carbide burr is high is appeared to be suitable to decrease the cutting force. The cutting force under the cutting for -X direction (down cut is dominant) is found to be larger than that under the cutting for +X direction (up cut is dominant).},
 pages = {5--11},
 title = {超硬バーを用いた傾斜面加工での切削条件が切削抵抗に及ぼす影響},
 volume = {59},
 year = {2017}
}