@article{oai:ir.kagoshima-u.ac.jp:00004719,
 author = {田中, 秀穂 and TANAKA, Hideho},
 journal = {鹿児島大学工学部研究報告, The research reports of the Faculty of Engineering, Kagoshima University},
 month = {Sep},
 note = {For contouring with the positioning/straight cut control NC milling machine, the profile must
be cut with stepped approximations, using the small straight movements of the table Δx, Δy in the
directions of the x and y axes.
Some methods are introduced for these approximate contourings. While, these approximate
cutting methods cause the unavoidable residual hight Δh, and this Δh is related to Δx, Δy and cutter
radius r. The relations among these are discussed on the cuttings of the circumferences and straight
lines had any angles of inclination which we encounter well in cutting operations generally.},
 pages = {15--24},
 title = {輪郭制御のできないNCフライス盤における近似輪郭切削について : 平面輪郭の場合},
 volume = {15},
 year = {1973}
}