@article{oai:ir.kagoshima-u.ac.jp:00007759,
 author = {田中, 豊 and TANAKA, Yutaka and 山崎, 和義 and YAMASAKI, Kazuyoshi},
 journal = {鹿児島大学工学部研究報告, The research reports of the Faculty of Engineering, Kagoshima University},
 month = {Nov},
 note = {In this paper, experimental investigation is carried out on the measurement of large bending strain of the material under impact bending using the short foil gage. The residual strain of cantilever subjected to impact load at its free end was measured with foil gage bonded on the compression surface. This value was compared with the value that had been calculated from the Bernoulli-Euler's assumption using the curvature measured from residual deformation of that beam. These experiments were performed on the four cases combined two kinds of gage and two kinds of bond.
It was then found that 7×10^<-2> strain can be measured by using polyimide gage bonded with epoxy resin bond.},
 pages = {137--141},
 title = {箔ゲージによる衝撃時の塑性曲げひずみの測定},
 volume = {19},
 year = {1977}
}