@article{oai:ir.kagoshima-u.ac.jp:00007765,
 author = {是枝, 賢一 and KOREEDA, Kenichi},
 journal = {鹿児島大学工学部研究報告, The research reports of the Faculty of Engineering, Kagoshima University},
 month = {Sep},
 note = {This paper describes some experiments about the electric discharge machining in　the
water bath by hand feeding from the outside, when the electrode of brass is vibrating by
magnetic force method under the condition of DC low working voltage supply. The results
are as follows.
(1) Maximan working speed can be obtained 0.24g/min by setting of DC 30 Volts power
and the electrode vibrating of 60 Hz to make a hole of 6mm in diameter and depth,
then the power supply is possible to do with 500 Watts.
(2) The amplitude of electrode is necessary to set in 0.2mm at least for discharge stability,
and the minimun voltage supply can be used at 20 Volts.
(3) A wave-form in the observed discharge current is found to be enveloped by high pulse
frequency components.},
 pages = {35--44},
 title = {水中放電加工に関する研究},
 volume = {17},
 year = {1975}
}