Item type |
紀要論文 / Departmental Bulletin Paper(1) |
公開日 |
2011-06-15 |
タイトル |
|
|
タイトル |
A study on bubble size and bubble rise velocity in a semi-cylindrical fluidized bed with a linear pitched perforated plate distributor |
|
タイトル言語 |
en |
タイトル |
|
|
タイトル |
直線配置多孔板を持つ半円筒形流動層における気泡径と気泡上昇速度の研究 |
|
タイトル言語 |
ja |
著者 |
幡手, 泰雄
右田, 光伸
碇, 醇
KING, Desmond F.
|
言語 |
|
|
言語 |
eng |
資源タイプ |
|
|
資源タイプ識別子 |
http://purl.org/coar/resource_type/c_6501 |
|
資源タイプ |
departmental bulletin paper |
要約 |
|
|
内容記述タイプ |
Other |
|
内容記述 |
A semi-cylindrical fluidized bed 15 cm in diameter, equipped with a transparent flat glass plate for the front wall, and a perforated plate distributor with 7 holes in a lineat pitch, was employed to visually observe bubbles in a fluidized bed. Bubble size and bubble rise velocity were measured for each well formed bubble by observation through the front window. The experimental conditions were as follows : four kinds of sand were used ( average particle size d_p=75, 189, 281 and 521 μm ) at excess gas velocities above minimum fluidization of 8, 12, 25 and 35 cm/s. The static bed height was 70 cm for all experiments. No effect of particle size on bubble behavior was detected. The average size of bubbles was well represented by Darton et al.'s model. The average velocity of the bubbles was in agreement with the model of Allahwalla and Potter. Each of these models was developed for three dimensional fluidized beds. |
|
内容記述言語 |
en |
収録雑誌名 |
ja : 鹿児島大学工学部研究報告
en : The research reports of the Faculty of Engineering, Kagoshima University
巻 27,
p. 177-184,
発行日 1985-11
|
作成日 |
|
|
日付 |
1985-11 |
|
日付タイプ |
Issued |
ISSN |
|
|
収録物識別子タイプ |
PISSN |
|
ISSN |
0451212X |
NII書誌ID(雑誌) |
|
|
収録物識別子タイプ |
NCID |
|
NC ID |
AN00040363 |
出版タイプ |
|
|
出版タイプ |
VoR |
|
出版タイプResource |
http://purl.org/coar/version/c_970fb48d4fbd8a85 |
NDC |
|
|
主題Scheme |
NDC |
|
主題 |
570 |
公開者・出版者 |
|
|
出版者 |
鹿児島大学 |
|
出版者言語 |
ja |
公開者・出版者 |
|
|
出版者 |
Kagoshima University |
|
出版者言語 |
en |