WEKO3
アイテム
LaNi_5を触媒ならびに水素吸蔵材として利用する接触的シクロヘキサン脱水素/二酸化炭素水素化サイクル反応操作に関する研究 -分離膜型反応器の基礎的検討-
http://hdl.handle.net/10232/12414
http://hdl.handle.net/10232/1241489c26e0e-3449-4466-afc9-8cb7ba210542
名前 / ファイル | ライセンス | アクション |
---|---|---|
AN00040363_v35_p53-59.pdf (777.2 kB)
|
|
Item type | 紀要論文 / Departmental Bulletin Paper(1) | |||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
公開日 | 2015-05-01 | |||||||||||||||||||||
タイトル | ||||||||||||||||||||||
タイトル | LaNi_5を触媒ならびに水素吸蔵材として利用する接触的シクロヘキサン脱水素/二酸化炭素水素化サイクル反応操作に関する研究 -分離膜型反応器の基礎的検討- | |||||||||||||||||||||
タイトル言語 | ja | |||||||||||||||||||||
タイトル | ||||||||||||||||||||||
タイトル | CYCLIC OPERATION OF CATALYTIC CYCLOHEXANE DEHYDROGENATION / CARBON DIOXIDE HYDROGENATION USING LaNi_5 AS A CATALYST AND AS A HYDROGEN RESERVOIR -A FUNDAMENTAL STUDY FOR MEMBRANE SEPARATION REACTOR- | |||||||||||||||||||||
タイトル言語 | en | |||||||||||||||||||||
著者 |
上村, 芳三
× 上村, 芳三
× 若松, 繁樹
× 大角, 泰章
× 幡手, 泰雄
|
|||||||||||||||||||||
言語 | ||||||||||||||||||||||
言語 | jpn | |||||||||||||||||||||
資源タイプ | ||||||||||||||||||||||
資源タイプ識別子 | http://purl.org/coar/resource_type/c_6501 | |||||||||||||||||||||
資源タイプ | departmental bulletin paper | |||||||||||||||||||||
要約 | ||||||||||||||||||||||
内容記述タイプ | Other | |||||||||||||||||||||
内容記述 | Cyclic operation experiments of catalytic cyclohexane dehydrogenation / carbon dioxide hydrogenation were carried out using LaNi_5 Particles as a catalyst and as a hydrogen reservoir. The final purpose of this study is to develop a membrane separation-type catalytic reactor. Five kinds of LaNi_5 particles ranging from 10 to 725 μm in mean diameter were used. After a 30 minute activation of LaNi_5 using hydrogen at 673 K, carbon dioxide and cyclohexane were allowed to flow through the LaNi_5 particle bed for each 30 minutes at 673 K, alternatively. The cycle recurred 4 times. The total time of the whole operation, therefore, was 4 hours. In the case of cyclohexane feed, cyclohexene, benzene and hydrogen were detected as products. Cyclohexane conversion increased with decreasing the mean diameter of LaNi_5, i.e., with increasing external surface area per unit mass of alloy. In the case of carbon dioxide feed, carbon monoxide was formed. Hydrogen also was detected in the outlet gas. Carbon monoxide yield also increased with decreasing the mean diameter of LaNi_5. To determine the amount of hydrogen in LaNi_5 available for carbon dioxide reduction, carbon dioxide was allowed to flow through the alloy bed until the carbon monoxide yield reached zero at 643, 653, 663 and 673 K, respectively. |
|||||||||||||||||||||
内容記述言語 | en | |||||||||||||||||||||
収録雑誌名 |
ja : 鹿児島大学工学部研究報告 en : The research reports of the Faculty of Engineering, Kagoshima University 巻 35, p. 53-59, 発行日 1993-09 |
|||||||||||||||||||||
作成日 | ||||||||||||||||||||||
日付 | 1993-09 | |||||||||||||||||||||
日付タイプ | Issued | |||||||||||||||||||||
ISSN | ||||||||||||||||||||||
収録物識別子タイプ | PISSN | |||||||||||||||||||||
ISSN | 0451212X | |||||||||||||||||||||
NII書誌ID(雑誌) | ||||||||||||||||||||||
収録物識別子タイプ | NCID | |||||||||||||||||||||
NC ID | AN00040363 | |||||||||||||||||||||
出版タイプ | ||||||||||||||||||||||
出版タイプ | VoR | |||||||||||||||||||||
出版タイプResource | http://purl.org/coar/version/c_970fb48d4fbd8a85 | |||||||||||||||||||||
NDC | ||||||||||||||||||||||
主題Scheme | NDC | |||||||||||||||||||||
主題 | 436 | |||||||||||||||||||||
公開者・出版者 | ||||||||||||||||||||||
出版者 | 鹿児島大学 | |||||||||||||||||||||
出版者言語 | ja | |||||||||||||||||||||
公開者・出版者 | ||||||||||||||||||||||
出版者 | Kagoshima University | |||||||||||||||||||||
出版者言語 | en |