WEKO3
アイテム
二連切欠き材の疲れについて : 応力集中係数および疲れ限度
http://hdl.handle.net/10232/12741
http://hdl.handle.net/10232/12741daf534b7-a875-4c6c-8b7e-42b9189b276d
名前 / ファイル | ライセンス | アクション |
---|---|---|
AN00040363_v18_p37-44.pdf (13.7 MB)
|
|
Item type | 紀要論文 / Departmental Bulletin Paper(1) | |||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
公開日 | 2015-06-17 | |||||||||||||||||
タイトル | ||||||||||||||||||
タイトル | 二連切欠き材の疲れについて : 応力集中係数および疲れ限度 | |||||||||||||||||
タイトル言語 | ja | |||||||||||||||||
タイトル | ||||||||||||||||||
タイトル | THE FATIGUE STRENGTH OF SHAFTS WITH TWO NOTCHES : On the Stress Concentration Factor and Fatigue Limit | |||||||||||||||||
タイトル言語 | en | |||||||||||||||||
著者 |
若原, 稔
× 若原, 稔
× 末永, 勝郎
× 永江, 次夫
|
|||||||||||||||||
言語 | ||||||||||||||||||
言語 | jpn | |||||||||||||||||
資源タイプ | ||||||||||||||||||
資源タイプ識別子 | http://purl.org/coar/resource_type/c_6501 | |||||||||||||||||
資源タイプ | departmental bulletin paper | |||||||||||||||||
要約 | ||||||||||||||||||
内容記述タイプ | Other | |||||||||||||||||
内容記述 | It has been recognizd that a series of closely spaced notches represnts lower degree of stress concentration than that of a single notch. As the first step, to obtain information for the fatigue strength in such a case, we studied following experiments ; (1) The stress concentration factor of flat bar specimene of Epoxy Resin with one or tow 60°-V notches of identical shape on both edges subjected to pure bending, was measured by the photo elastic method varying the root radius of notches. (2) We measured the fatigue strength of shaft of the carbon steel for machine structural use, S35C, with one or two 60°-V groove notches subjected to rotary bending. The results obtained are summarized as follows ; (1) The experimental values of stress concentration factor for a single notch are almost coincident with Neuber's theoritical ones. (2) In computing the stress concentration factor, we suggest to use the effective notch depth at the end notches instead of actual notch depth, and obtained good results. (3) The root radius of notch at the branch point, ρ_0 is nearly 0.4~0.5mm for the tow notch specimens as single ones. (4) The fatigue crack initiated at a point of maximum stress, slightly out of the notch bottom. |
|||||||||||||||||
内容記述言語 | en | |||||||||||||||||
収録雑誌名 |
ja : 鹿児島大学工学部研究報告 en : The research reports of the Faculty of Engineering, Kagoshima University 巻 18, p. 37-44, 発行日 1976-12 |
|||||||||||||||||
作成日 | ||||||||||||||||||
日付 | 1976-12 | |||||||||||||||||
日付タイプ | Issued | |||||||||||||||||
ISSN | ||||||||||||||||||
収録物識別子タイプ | PISSN | |||||||||||||||||
ISSN | 0451212X | |||||||||||||||||
NII書誌ID(雑誌) | ||||||||||||||||||
収録物識別子タイプ | NCID | |||||||||||||||||
NC ID | AN00040363 | |||||||||||||||||
出版タイプ | ||||||||||||||||||
出版タイプ | VoR | |||||||||||||||||
出版タイプResource | http://purl.org/coar/version/c_970fb48d4fbd8a85 | |||||||||||||||||
NDC | ||||||||||||||||||
主題Scheme | NDC | |||||||||||||||||
主題 | 531 | |||||||||||||||||
公開者・出版者 | ||||||||||||||||||
出版者 | 鹿児島大学 | |||||||||||||||||
出版者言語 | ja | |||||||||||||||||
公開者・出版者 | ||||||||||||||||||
出版者 | Kagoshima University | |||||||||||||||||
出版者言語 | en |